T31 Series Design Features
Mechanical Seals
All bronze fitted pumps have Buna rubber, high temperature
carbon and ceramic seats, while Stainless Steel pumps feature Viton rubber
and ceramic seats. Optional seats and materials are available.
300 PSI Case Working Pressure
Rigid stucture is designed for maximum casing strength.
Water Flinger
A water flinger provides added protection to ball bearings
in the event of seal leakage.
End Suction/Top Discharge
T31 Seriec pumps are compact to allow installation in
small areas. The discharge can be rotated to 90°, 180°, 270°
positions to faciliate the most convient installation.
Simple Construction
T31 Series pumps contain only three major componenets,
allowing for easy service.
Best Efficiency
New pump designs optimize efficiency for each size.
Non-Cavitating
T31 Series pumps may be operated under adverse inlet
conditions without audible or measurable cavitation.
Low NPSH
New inlet design provides superpior fluid handling ability
with low head inlet conditions.
100% Tested
Every pump is fully tested to verify performance prior
to shipment.
Volatile Fluid Handling
The turbine impeller handles vapors up to 20% by volume,
minimizing the possibility of vapor lock.
"O"Ring Gaskets
"O"ring gaskets are used throughout the T31
Series pumps to assure positive sealing.
Standard Motors
Close Coupled T31 pumps use standard "C" face single
phase 60/50 hertz 115-230 volt motors with a keyed stainless steel shaft.
|
